Unlike the advertised expensive brands of Chinese assembly, the iCLEBO Arte robot vacuum cleaner was developed and assembled entirely in South Korea, which in itself speaks a lot about its quality. It took the company 7 years to develop this model - from the creation of the line in 2005 to the release of Arte in 2012. The result is a device that is almost completely devoid of flaws and has a rich functionality.
Specifications
- Provides dry and wet cleaning.
- Dust collector with 600 ml cyclone filter.
- Wet cleaning - wiping the floors with the supplied microfiber cloth.
- Li-lon battery with a capacity of 2200 mAh, lasts for 120 minutes of operation, charging lasts 110 minutes.
- Noise level 55 dB.
- Develops speed up to 18 m / min.
- Control from the remote control, programming by days of the week.
The average cost is 28,000 rubles.
Equipment
- Dock station.
- Power supply unit and wire.
- Infrared remote control and two batteries for it.
- User's manual on paper and disk.
- Side brushes.
- Two spare filters.
- Main brush.
- Scallop for cleaning.
- Microfiber cloth and pallet.
- Magnetic tape to limit the cleaning space.
- 2-sided self-adhesive strip.
Appearance
The model is characterized by a stylish and expensive design. It is presented in different colors, which can be recognized by the markings:
- YCR-M05-10, Carbon - dark gray and black case with orange inlay around.
- YCR-M05-20, Silver - light gray and black in a circle.
- YCR-M05-30, Black Edition - Matte black body.
- YCR-M05-50, Red - red with black inset around.
- YCR-M05-50, Sakura is a designer model with a pink pattern on a dark gray body.
The robot is almost circular in shape, but the bumper has a slightly larger radius than the rear of the body. At the bottom, the edges are beveled to facilitate passing obstacles. The top panel has three touch buttons, a display and status indicators for the vacuum cleaner. Here, in a single block with them, a camera directed upwards is located. All elements are covered with a sturdy plate for protection.
The front half of the body is surrounded by a spring-loaded bumper, in front of it there is a small protrusion - this is the highest point of the model, the distance from the floor to it is 8.8 cm. The front part of the bumper is covered with a strip of polyethylene, which protects it from scratches. A dust collector is fixed at the back, which fits into the overall circumference of the vacuum cleaner. On the right side there is a power connector and a button for disconnecting the device.
At the bottom there are two contact pads, a front roller without turns, two side brushes, a battery cover, two drive wheels on spring-loaded levers, a main brush compartment and a bottom of a dust collector made of translucent material to determine its filling.
Functional
The navigation system consists of a video camera, mechanical sensors that respond to collisions and movement of the bumper, IR sensors that determine the proximity of an obstacle are located in the bumper recess. There are also infrared height change sensors located on the bottom, closer to its edge in the front. IR sensors for locating the base on the front of the bumper. The sensor of separation from the floor, when triggered, the vacuum cleaner stops its work. Gyro sensor for orientation.
The base of the vacuum cleaner is curiously arranged.Under its top cover you can find a comb brush for cleaning the dust container, the main brush, sensors and other items from the kit. On the inside of the cover there is a table with tips for error codes. A compartment with an external power adapter installed in it is hidden behind the back cover. If necessary, the adapter can be removed to charge the vacuum cleaner without using the base. The base area of the base is impressive, with rubber pads glued to it, which keep the base from moving during the automatic installation of the robot on it.
The robot can make a turn on the spot without increasing the occupied area due to the round shape and the arrangement of the wheels on the same diameter with the circle. Maneuverability is added by a low height and a sleek hull around the entire perimeter.
During the cleaning process, the two front brushes work, they scoop up the debris to the center, where a stationary rubber scraper directs them into the dust container through the suction port. For wet cleaning, a moistened microfiber cloth is attached to a special bar behind the main brush. The wet cleaning mode turns on automatically after installing the bar. At the same time, it is impossible to use the robot in wet rooms, as well as its operation to collect water.
The vacuum cleaner has five main operating modes:
- Auto - one-time cleaning from one point to another with garbage collection on the entire area between them.
- Chaotic movement - an arbitrary direction of work in a given area, the mode is limited in time.
- Maximum - the specified area is cleaned until the battery runs out.
- Local - cleaning on one specified area in the room.
- Manual - the direction of movement is indicated by the IR remote control.
It is noteworthy that the robot has a function for overcoming obstacles - it allows you to pass obstacles up to 20 mm. If this function is not enabled, the maximum obstacle threshold is 15mm. There are cleaning schedule settings for the days of the week.
Advantages and disadvantages
Notable sides of the model:
- Good navigation system and several operating modes.
- The dust container is easy to clean.
- Low height.
- Two side brushes.
- Wet cleaning nozzle.
- Magnetic tape to limit the working space.
- Manual robot control system from the remote control.
Negative sides:
- The model is more likely for final cleaning, does not clean the surface perfectly, but with regular use it allows you to improve the quality of manual cleaning with the main vacuum cleaner.
- In the event of an error after restarting, the program starts over.
See also - 10 best robot vacuum cleaners under 30,000 rubles according to customer reviews
See also: robotic vacuum cleaners up to 25,000 rubles
